STUDI PENERAPAN AKUSTIK PADA GERBONG KERETA API SRI LELAWANGSA

Riri Angriani Nasution, Zubair Aman Daulay, Abdul Halim Daulay

Abstract


This study aims to determine the noise level in the Sri Lelawangsa train carriage without the addition of sound-absorbing materials and to determine the thickness of the sound-absorbing material needed to meet the acoustic comfort standard if it is simulated in a sample testing room. Noise level measurements were carried out on the Sri Lelawangsa train carriages in conditions without the addition of sound-absorbing materials. This noise level measurement was carried out in three carriages of the Sri Lelawangsa train, namely the train carriage, engine carriage, and passenger carriage, the source of noise comes from outside and inside the Sri Lelawangsa train. The study of the application of acoustics was carried out in a sample testing room made of cardboard boxes with a length of 34cm, width 25, cm and height 32 cm, and the source of noise in the sample testing room was the speaker. The absorbent material used to meet the acoustic comfort standard is pyramidal foam which is placed on the nearest side of the sound source. The measuring instrument used to measure noise on the Sri Lelawangsa train is a sound level meter and the Surfer Golden V16 software is used to describe the distribution of sound in the Sri Lelawangsa train carriage. The noise level on the Sri Lelawangsa train still exceeds the quality standard set by the Regulation of the Minister of Transportation of the Republic of Indonesia No. 75 of 2015 which is 80 dB. The highest noise level in the passenger car is at point (1) 82.81 dB. The machinist carriage is 84.70 dB, and the engine carriage is at point (2) 88.92 dB. After measuring the reverberation time on the Sri Lelawangsa train carriage, it is known that the surface area of the sound absorbing material needed to meet the reverberation time standard on the Sri Lelawangsa train carriage is 34,83 m3 with an absorption coefficient (α) of 0.58 according to with the provisions of SNI 03-6306-2000.

Keywords


Pyramid Foam; Carriage; Sri Lelawangsa Train; Noise

References


1. Puabdillah, M. F. (2017). Analisa Kebisingan Pada Gerbong Kereta Bandara Soekarno Hatta yang Disebabkan low Ac Unit ACI-4001 Dengan Menggunakan Analisa CFD (Computational Fluid Dynamic). Skripsi, Institut Teknologi Sepuluh November, Surabaya.

2. Mediastika, C. E, (2009). Akustika Bangunan. Yogyakarta: Erlangga

3. Halliday, D., Resnick, R., & Walker. (2010). Fisika Dasar Edisi 7 Jilid 3. Jakarta: Erlangga.

4. Sujarwanto, T., Prajitno, G., & Yuwana, L. (2014). Kebisingan di Dalam Kabin Masinis Lokomotif Tipe CC201. Jurnal Sains dan Seni ITS, 3(2), B101-B106.

5. Keputusan Menteri Lingkungan Hidup No.48/MEN.LH/11/1996 tentang Baku Mutu Tingkat Kebisingan.

6. Peraturan Menteri Ketenagakerjaan Republik Indonesia. (2018). Keselamatan dan Kesehatan Kerja No. 5 Pasal 1 ayat 1.

7. Dwi, N. (2015). Analisis Pengaruh Tingkat Kebisingan dan Getaran Kereta Api Terhadap Tekanan Darah Ibu Rumah Tangga di Pemukiman Pinggiran Rel Kereta Api Jalan Ambengan Surabaya. Skripsi, Universitas Air langga, Surabaya.

8. Haryono, S. H. (2011). Higiene Lingkungan Kerja. Yogyakarta: Mitra Cendikia Press.

9. Sela, J. (2018). Pengaruh Jarak Pemukiman Terhadap Tingkat Kebisingan Pada Jalur Kereta Api Jenis Ekonomi di Wilayah Kelurahan Winongo Kota Madun. Skripsi, Stikes Bhakti Husada Mulia.

10. Komite Nasional Keselamatan Transportasi. (2003). Laporan Investigasi Kecelakaan Kereta Api Tabrakan Antara Rangkaian KA 146 Empu Jaya Dengan Rangkaian KA 153 Gaya Baru Malam.




DOI: http://dx.doi.org/10.31258/jkfi.20.2.171-178

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Indexing by:

  

 

Image